![]() ![]() Remember to clear the memory of the clicker keypad before programming and troubleshoot any issues that may arise. By following the step-by-step instructions provided in this article, you can easily sync the clicker keypad with your garage door opener. Programming a clicker keypad to your Genie garage door opener can enhance the convenience and security of accessing your garage. If the LED light on the motor head of the garage door opener does not blink after pressing the “Learn” or “Smart” button, repeat the programming steps from the beginning.Make sure that there are no obstructions blocking the signal between the clicker keypad and the Genie garage door opener.Check the batteries of the clicker keypad and replace them if necessary.Ensure that the clicker keypad is within range of the Genie garage door opener signal.In case you encounter any issues during the programming process, here are some troubleshooting tips to help you: Test the programmed PIN code by entering it on the clicker keypad and operating the garage door opener. ![]() Wait for the LED light on the Genie garage door opener motor head to blink, indicating a successful programming connection with the clicker keypad.Press the “Learn” or “Smart” button once.Within 30 seconds, locate the “Learn” or “Smart” button on the back of the Genie garage door opener motor head.Press the “Up/Down” arrow button on the clicker keypad to send the programming information to the Genie garage door opener.Press and hold the “Program” button on the clicker keypad once again until the LED light blinks. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |